| Thermoplastic polyurethane (TPU) | About 70 Shore A to 75 Shore D, depending on grade | Often about −30°C to 80°C; some grades allow higher temperatures | High abrasion and tear resistance; good elasticity; can be processed as a thermoplastic | Heat, moisture, and chemical resistance vary significantly by TPU chemistry and grade | Generally strong abrasion resistance; polyester-based grades often resist oils well, while polyether-based grades usually offer better hydrolysis resistance | Wheels, cable jackets, seals, flexible hoses, protective parts | Buyers prioritizing wear resistance, toughness, and flexible-part performance |
| Styrenic thermoplastic elastomer (TPE-S) | Commonly about 20 to 50 Shore A, with harder grades available | Often about −40°C to 100°C, grade-dependent | Flexible, readily molded, and suitable for many overmolding and consumer-product designs | Usually less resistant to heat, oils, and long-term compression than many vulcanized rubbers | Good weathering in suitable formulations; oil and solvent resistance is generally limited | Grips, soft-touch components, flexible handles, seals, household products | Buyers seeking easy thermoplastic processing, a soft feel, and efficient high-volume production |
| Silicone rubber | Commonly about 20 to 80 Shore A | Often about −50°C to 200°C; specialty grades may extend beyond this range | Broad temperature capability; remains flexible at low temperatures; good electrical insulation | Typically lower tear and abrasion resistance than TPU; can be more expensive than general-purpose elastomers | Good resistance to weather, ozone, and aging; performance in fuels and many solvents is limited | Gaskets, medical and food-contact components in suitable grades, electrical insulation, bakeware | Buyers needing a wide operating-temperature range or stable outdoor and electrical performance |
| EPDM rubber | Commonly about 40 to 90 Shore A | Often about −40°C to 120°C; some compounds are rated higher | Excellent resistance to weathering, ozone, water, and many outdoor conditions | Generally unsuitable for petroleum oils, fuels, and many hydrocarbon fluids | Very good weather, ozone, and water resistance; poor compatibility with mineral oils and fuels | Outdoor seals, roofing membranes, weatherstripping, water-system components | Buyers needing durable outdoor, water, or weather-exposed parts without oil contact |
| Nitrile rubber (NBR) | Commonly about 40 to 90 Shore A | Often about −30°C to 100°C; formulation affects the usable range | Good resistance to many petroleum oils and fuels; widely used for sealing | Weather and ozone resistance are generally weaker than EPDM; low-temperature flexibility varies by grade | Good oil and fuel resistance for compatible compounds; limited resistance to ozone and outdoor aging | Oil seals, fuel-system components, industrial hoses, gaskets | Buyers needing an economical elastomer for oil- or fuel-contact applications |
| Flexible polyvinyl chloride (PVC) | Varies widely; commonly around 50 to 95 Shore A | Often about −10°C to 60°C, depending on plasticizer and formulation | Can be economical, easy to color, and suitable for many flexible molded or extruded products | Cold flexibility and long-term heat performance can be limited; plasticizer migration may matter in some uses | Good resistance to water and many dilute acids and alkalis; compatibility with oils and solvents depends on formulation | Flexible tubing, wire and cable insulation, flooring, profiles, protective covers | Buyers prioritizing cost, color options, and flexible extrusion or molding for moderate conditions |