| General-purpose tantalum sheet | Unalloyed tantalum, ASTM Grade R05200 | Commercially pure tantalum; a common unalloyed grade under ASTM B708. | Fabricated components and corrosion-resistant equipment where the specified chemical environment is compatible with tantalum. | Confirm the required chemistry, thickness, surface condition, and applicable ASTM B708 requirements. |
| Unalloyed material with a different melting route | Unalloyed tantalum, ASTM Grade R05400 | Unalloyed tantalum grade; production route and certification should be confirmed with the supplier. | Projects that call for this grade or specify particular material-production and inspection requirements. | State the grade explicitly on the purchase order and verify the material test report and traceability. |
| Higher-temperature strength than unalloyed tantalum | Tantalum–2.5% tungsten, ASTM Grade R05255 | Tantalum alloy with nominally about 2.5% tungsten; confirm permitted chemistry against the governing specification. | Applications where the designer selects a tantalum–tungsten alloy for added strength compared with unalloyed tantalum. | Do not assume pure-tantalum physical-property values apply unchanged to the alloy; check design data for the exact condition and temperature. |
| Greater alloying for demanding mechanical service | Tantalum–10% tungsten, ASTM Grade R05240 | Tantalum alloy with nominally about 10% tungsten; confirm permitted chemistry against the governing specification. | Components for which the engineering specification calls for a higher-tungsten tantalum alloy. | Confirm formability, joining procedure, thickness tolerance, and design allowables for the selected product condition. |
| Corrosion service involving hydrofluoric acid or fluoride media | No grade is an automatic choice | Tantalum is resistant to many corrosive environments, but hydrofluoric acid and fluoride-containing media can attack it. | Use only after checking the actual chemical concentration, temperature, and process conditions with a qualified materials engineer. | Do not select tantalum from a general corrosion-resistance claim alone; validate the complete service environment. |
| High-temperature design reference for pure tantalum | Unalloyed tantalum property baseline | Density: 16.69 g/cm³. Melting point: approximately 3,017°C. | Useful as a material-identification and preliminary comparison reference—not as a service-temperature rating. | The melting point does not establish a safe operating temperature. Consider atmosphere, loads, fabrication, and design limits. |
| Purchase dimensions and documentation | Sheet, plate, or strip to the project specification | ASTM B708 covers tantalum and tantalum-alloy plate, sheet, and strip. | Custom-cut or stock material for the required component dimensions. | Specify thickness, width, length, tolerances, grade, surface condition, inspection, and certification. Available stock sizes vary by supplier. |