| Compact utility | 0.5 t (about 4.9 kN) | Rated pull is normally specified at the first rope layer unless the datasheet states otherwise. | 3–4 layers | Automatic load-holding brake, often electromagnetic or mechanical | Check supply voltage, mounting space, and the duty cycle stated by the manufacturer. |
| Light-duty handling | 1 t (about 9.8 kN) | Confirm whether the stated figure is line pull or a different measure such as lifting capacity. | 3–4 layers | Load-holding brake matched to the motor and drive | Use the rated pull for the intended rope layer, not just the maximum capacity printed in a listing. |
| Workshop duty | 2 t (about 19.6 kN) | Pull available at the drum generally decreases as rope builds up on the drum. | 3–5 layers | Electromagnetic or mechanical holding brake | Allow for rope, hook, and rigging weight when assessing the load and system limits. |
| Vehicle or equipment recovery | 3 t (about 29.4 kN) | Published pull ratings should be checked against the first-layer rating and the maker’s load chart. | 3–5 layers | Automatic brake; dynamic braking may also be specified | Recovery loads can exceed static vehicle weight; use suitable anchors and rated rigging. |
| Industrial material handling | 5 t (about 49.0 kN) | Capacity depends on the effective drum radius and the number of rope layers. | 4–5 layers | Load-holding brake, with system-level braking requirements verified | Confirm the required operating class, starts per hour, and expected running time. |
| Heavy workshop or plant duty | 8 t (about 78.5 kN) | Use the model-specific line-pull chart; capacity is not necessarily constant across layers. | 4–5 layers | Brake selected for the rated load and operating conditions | Check the supporting structure, reeving arrangement, and electrical protection. |
| Heavy industrial handling | 10 t (about 98.1 kN) | Rated line pull is distinct from the load capacity of the complete lifting system. | 4–5 layers | Load-holding brake; independent braking provisions may be required by the application | Verify applicable local codes and whether the unit is approved for lifting people or loads. |
| Large-capacity installation | 15 t (about 147.1 kN) | Check pull at each working layer and the specified rope arrangement. | 4–6 layers | Brake configuration specified for the complete drive system | Assess heat dissipation, operating frequency, and emergency-stop requirements. |
| Very heavy industrial duty | 20 t (about 196.1 kN) | Capacity figures must be interpreted using the manufacturer’s exact rating conditions. | 4–6 layers | Engineered load-holding brake system | Review structural loads, rope fleet angle, and inspection and maintenance access. |
| Project-specific heavy duty | 30 t (about 294.2 kN) | Configuration-specific; no single line-pull value applies to every drum layer or reeving setup. | Project-specific | Application-engineered braking and control system | Require a complete technical proposal covering load cases, duty, controls, and applicable standards. |