| 1 | Confirm the temperature duty | Compare the motor’s stated maximum ambient temperature with the actual ambient temperature at the motor location. Distinguish ambient temperature from the motor’s internal winding temperature, and check whether the rating changes with load or speed. | Document the expected temperature range, exposure duration, load, and operating speed. Request the manufacturer’s temperature-versus-load limits; do not treat a brief peak-temperature rating as continuous-duty approval. |
| 2 | Assess environmental protection | Compare protection against dust, water, oil, washdown, and process contaminants separately. IP ratings under IEC 60529 describe protection against ingress; they do not, by themselves, establish high-temperature capability or chemical compatibility. | Match the required IP rating and any enclosure or sealing requirements to the installation conditions. Confirm that seals, connectors, cable entries, and feedback devices are suitable for the same temperature and exposure. |
| 3 | Check thermal and electrical limits | Compare rated torque, peak torque, continuous current, insulation system, and permitted winding temperature. High ambient temperatures reduce the motor’s ability to dissipate heat and can require derating. | Review the motor’s continuous-duty curves at the intended ambient temperature and mounting arrangement. Verify that the drive, cable insulation, connectors, and protective settings are compatible with the motor’s current and temperature limits. |
| 4 | Evaluate feedback and control | Compare encoder or resolver temperature limits, feedback accuracy, cable requirements, and compatibility with the servo drive. A motor’s temperature rating does not necessarily apply to its feedback sensor or connector. | Check the temperature limits of the complete feedback chain, including sensor, connector, cable, and drive input. Confirm position resolution and control performance meet the machine’s requirements at operating temperature. |
| 5 | Review reliability and service life | Compare bearing type and lubrication limits, sealing design, thermal cycling capability, and published life assumptions. Lubricant life and bearing life can be affected by temperature, speed, load, and contamination. | Ask for bearing and lubrication temperature limits, maintenance guidance, and the conditions used for any life estimates. Check whether the application involves frequent starts, vibration, shock loads, or repeated heat-up and cool-down cycles. |
| 6 | Verify mounting and heat management | Compare mounting orientation, flange and shaft requirements, surrounding airflow, and heat transfer to nearby equipment. Enclosures, insulation, and restricted airflow can increase operating temperature. | Confirm the permitted mounting arrangement and required clearances. Review how heat will be removed in the installed configuration, and verify that the shaft, coupling, cables, and adjacent components tolerate the same environment. |
| 7 | Compare documentation and support | Compare availability of application engineering, test documentation, installation instructions, troubleshooting help, repair options, and replacement parts. Support capability is particularly important when access or downtime is costly. | Request written operating limits, wiring and maintenance documents, expected response channels, repair process, and spare-parts availability. Confirm how warranty terms address operation at elevated temperatures and in harsh environments. |