| Bag fit before shrinking | Place the product in the bag without stretching the film. Check clearance around the widest and tallest points. | The product loads smoothly, sits in the intended position, and has enough film for a complete seal. | The bag is difficult to load, pulls tightly over corners, or leaves excessive loose film. | Try a different bag width or length. Allow for product shape, loading method, and the seal area. |
| Fit around irregular shapes | Test the bag on products with handles, protrusions, sharp edges, or uneven profiles. | The film covers the full product without snagging or being forced over edges. | Film catches on a protrusion or becomes strained at a corner. | Consider a larger or gusseted bag, or protect sharp edges before packing. Confirm the film is suitable for the application. |
| Seal continuity | Make sample seals using the intended sealer settings. Inspect the full seal line after cooling. | The seal is continuous, closed, and free of open channels, folds, or burned areas. | Gaps, wrinkles, weak spots, or discoloration appear along the seal. | Check film compatibility, sealing temperature, dwell time, pressure, and seal-bar cleanliness; change one variable at a time. |
| Seal strength | Handle the cooled package and gently pull the film near the seal. For production approval, use a consistent documented test method. | The seal remains closed during normal handling and does not peel apart readily. | The seal opens under light handling or tears directly along the seal line. | Review sealing conditions and the seal area. Follow the film and equipment supplier’s recommendations. |
| Finished shrink appearance | Process samples using the intended heat source and inspect all sides after the package has cooled. | The film is reasonably smooth and conforms to the product without unacceptable loose areas. | Excessive wrinkles, loose panels, or uneven shrink are visible. | Check bag sizing, product placement, airflow, and heating consistency. Use the film’s recommended processing range. |
| Holes, tears, or distortion | Inspect edges, corners, and printed or sensitive surfaces immediately after shrinking. | No holes or tears are present, and the product retains its acceptable shape and surface condition. | Film punctures at sharp points, or the product is affected by heat. | Use edge protection or a more suitable film; reduce or redistribute heat in line with equipment and film guidance. |
| Repeatability | Pack several samples in succession using the same operator, settings, and loading method. | Fit, sealing, and appearance remain consistent across the sample run. | Results vary from package to package. | Standardize loading and machine settings, and check for changes in film, equipment condition, or product dimensions. |