| Fuel | Fuel fill, supply, return, and vent lines for gasoline or diesel systems. | Use hose explicitly rated for the fuel type and the intended fill, feed, return, or vent duty. Check compatibility with fuel blends, including ethanol-containing gasoline where applicable, as well as working pressure, temperature, and fuel-vapor permeation requirements. | Look for applicable marine fuel-hose approvals or markings, such as SAE J1527 or ISO 7840, and confirm the exact hose type is suitable for the intended location and duty. Follow the vessel’s applicable regulations and the hose manufacturer’s documentation. | Use the correct inside diameter and approved clamps or fittings. Avoid kinks, chafe, excessive bending, and unsupported runs. Never substitute general-purpose or potable-water hose for fuel hose. |
| Exhaust | Wet marine exhaust, including sections carrying a mixture of cooling water and exhaust gas. | Choose hose specifically designed for marine exhaust and rated for the actual wet or dry exhaust arrangement, temperature, and pressure. Wet-exhaust hose and dry-exhaust components are not interchangeable; observe the hose’s stated temperature limits. | Check for an applicable marine exhaust-hose specification, such as SAE J2006 or ISO 13363, and verify the product’s intended exhaust configuration and ratings in its technical documentation. | Follow the engine and exhaust-system maker’s routing requirements, including required rise, fall, support, and waterlock arrangement. Keep the hose clear of hot surfaces and inspect for soft spots, cracking, and heat damage. |
| Bilge | Bilge-pump discharge and other approved drainage runs. | Match the hose to the pump’s discharge pressure and, where applicable, suction or vacuum duty. Consider the bilge contents: ordinary drainage service may differ from exposure to fuel, oil, or chemicals. Confirm the hose is compatible with the expected fluid and environment. | There is no single universal hose specification for every bilge application. Use the pump maker’s required hose size and pressure limits, applicable vessel rules, and the hose manufacturer’s service ratings. | Do not reduce the pump outlet size unless the pump instructions allow it. Secure the run against movement and chafe, and route discharge to the approved outlet. Use oil-resistant hose when oil or fuel exposure is expected. |
| Potable Water | Fresh-water fill, tank connections, and cold- or hot-water distribution. | Select hose intended for drinking-water contact and suitable for the system’s temperature and pressure. Confirm whether it is rated for hot water if used on a heated-water line, and check that its materials will not impart unacceptable taste or odor. | Where required or appropriate, verify drinking-water-contact certification or compliance, such as NSF/ANSI/CAN 61, for the specific product and intended use. A general statement of material suitability is not a substitute for checking the product’s documentation. | Keep potable-water hose separate from fuel, waste, and bilge plumbing. Use compatible fittings, avoid contamination during installation, and flush and sanitize the system according to vessel and equipment instructions. |