| Nominal diameter | The rope diameter specified for the crane’s sheaves, drum, and reeving system. | Use the diameter required by the crane design. A larger diameter is not automatically a suitable upgrade: it must fit the grooves and drum and meet applicable minimum sheave-to-rope diameter requirements. | Check the crane manual and rope specification. Measure a new or in-service rope across the widest outer strands using a suitable rope-diameter gauge; do not measure across a valley between strands. |
| Rope construction | Strand arrangement, core type, and whether the rope is rotation-resistant. | Common crane rope constructions include 6-strand ropes with fibre or independent wire rope cores, and rotation-resistant constructions. The correct type depends on reeving, lift height, load control, and crane design. | Match the construction and core stated on the crane documentation. Do not substitute a rotation-resistant rope or a different core type without approval. |
| Rope grade | The rope tensile-strength grade, commonly designated in N/mm² (MPa), such as 1770, 1960, or 2160. | A higher grade can provide a higher minimum breaking force for a given diameter and construction, but it is not by itself proof that a rope is compatible with the crane or appropriate for the duty. | Confirm the grade on the rope certificate and verify it against the crane manufacturer’s requirements and the applicable rope standard. |
| Minimum breaking force | The certified minimum breaking force (MBF) for the complete rope, not the tensile-strength grade alone. | Required MBF depends on the maximum rope-line pull, reeving arrangement, design factor, and governing requirements. There is no single universal MBF for a given diameter across all rope constructions and standards. | Use the MBF on the manufacturer’s certificate or applicable product table for the exact diameter, construction, core, and grade. Do not estimate it from diameter alone. |
| Design factor and line pull | The maximum tension in the rope line and the design factor required for the crane application. | As a basic screening relationship, required MBF must be at least the required design factor multiplied by the maximum rope-line pull. The design factor must come from the applicable crane design standard or manufacturer—not from a generic rule of thumb. | Have a qualified crane engineer confirm the governing load case, reeving efficiency, dynamic effects, and required design factor. |
| Sheaves, drum, and operating duty | Groove profile, sheave and drum diameters, fleet angle, bending cycles, speed, and operating environment. | Frequent bending, small sheaves, high duty cycles, abrasion, heat, and corrosion can affect rope life. Rope construction and lubrication should suit the actual duty and environment. | Compare the proposed rope with the crane manufacturer’s limits and inspection criteria. Check that the drum and sheave grooves are compatible and in serviceable condition. |
| Identification and traceability | Rope diameter, construction, grade, core, lay, coating or finish, and manufacturing documentation. | Keep the replacement rope’s specification consistent with the approved crane design. Changes can affect performance, compatibility, and inspection requirements. | Verify the rope marking, certificate, and purchase specification before installation; retain records for maintenance and inspection. |