| Prepare pipe ends for butt welding | Carbon steel, stainless steel, or alloy steel | Diameter and wall thickness vary by project; confirm the machine’s stated capacity before selection. | Single bevel, commonly 30° or 37.5° from the plane perpendicular to the pipe axis; a root face may also be specified. | Match the bevel angle, root face, and dimensional tolerances to the approved welding procedure or joint drawing. | Adjustable bevel angle, controlled root-face setting, rigid clamping, and repeatable end preparation. |
| Remove sharp edges after cutting | Carbon steel, stainless steel, aluminum, or copper alloys | Small-bore tubing through larger pipe, depending on the machine’s tooling and clamping range. | Light external chamfer or rounded edge; specify the required edge break on the drawing. | Remove burrs without reducing the pipe wall or changing the end geometry beyond the permitted limit. | Suitable cutting tools for the material, secure support, and adjustable feed or depth control. |
| Prepare both sides of a pipe end | Typically steel pipe used in welded assemblies | Use the workpiece outside diameter and wall thickness to verify machine capacity. | Combined internal and external chamfer, or a double-bevel profile when specified. | Keep the internal and external profiles concentric and consistent around the full circumference. | Internal and external tooling, stable alignment, and sufficient clearance for the pipe length and setup. |
| Chamfer thick-wall pipe for welding | Carbon steel or alloy steel | Thick-wall workpieces require particular attention to cutting force, tool reach, and clamping capacity. | Single- or compound-bevel preparation with a defined root face, as shown on the joint drawing. | Control the bevel geometry and avoid excessive heat, chatter, or uneven material removal. | High-rigidity construction, adequate drive capacity, robust tooling, and secure workholding. |
| Prepare thin-wall tubing | Stainless steel, aluminum, copper, or thin-wall steel | Confirm minimum wall thickness and allowable clamping pressure with the machine specification. | Small external chamfer or specified weld-preparation profile; avoid an unnecessarily large edge break. | Prevent tube deformation and maintain a clean, square end before chamfering. | Low-distortion clamping, fine feed control, sharp tooling, and support appropriate to the tube diameter. |
| Produce repeatable ends in batch production | Material depends on the production part | Choose capacity around the full range of part diameters and wall thicknesses in the batch. | Consistent chamfer angle, width, or root face across all parts. | Set up against a documented inspection method and check representative parts during production. | Quick changeover, repeatable settings, accessible tooling, and compatibility with the production workflow. |