| Thread system and size | Confirm the thread standard, nominal diameter, and pitch on the motor shaft and mating component. | Metric examples: M6 × 1, M8 × 1.25, and M10 × 1.5 are common coarse-thread sizes. Inch-thread examples include UNC and UNF; these are not interchangeable with metric threads. | Check the motor drawing or specification and use a matching thread gauge. Do not force a nut or coupling onto a thread that does not turn freely by hand. |
| Thread tolerance and fit | Verify the required thread tolerance class and fit for the application. | Metric thread tolerances are covered by ISO 965. The required tolerance depends on the shaft, mating part, and manufacturer’s design. | Inspect for damaged, flattened, or contaminated thread crests. Replace or repair parts only using an approved method; do not compensate for a poor fit by overtightening. |
| Thread engagement | Check usable thread length, fastener length, and clearance at the bottom of any blind hole. | The fastener must achieve the engagement specified by the motor or component manufacturer without bottoming out or contacting internal motor parts. | Confirm engagement with the actual assembled parts. Never assume that a longer bolt is safer; excess length can damage internal components or prevent the joint from clamping correctly. |
| Load and torque capacity | Confirm that the shaft and threaded joint can withstand the operating torque, axial load, and any shock or reversing loads. | Allowable loads and tightening torque are application- and design-specific; use the motor and coupling specifications rather than a generic torque value. | Use a calibrated torque tool when a specified torque is provided. Do not exceed the manufacturer’s limit or apply impact tools unless explicitly permitted. |
| Shaft dimensions and runout | Check shaft diameter, usable length, shoulder position, and allowable runout against the mating component. | Dimensional limits depend on the motor and driven equipment. Use the drawing or specified measurement limits for the particular assembly. | Measure with suitable inspection tools and keep bearing surfaces clean. Do not bend or side-load the shaft during fitting. |
| Alignment and balance | Verify that the connected part is aligned and suitable for the motor’s speed and duty. | Permitted misalignment and balance requirements depend on the motor, coupling, operating speed, and application. | Follow coupling instructions, check alignment before operation, and investigate unusual vibration, noise, or heating immediately. |
| Material and environment | Match shaft and fastener materials and finishes to the load, temperature, corrosion exposure, and operating environment. | Material strength, corrosion resistance, and coating can affect joint capacity and compatibility; verify these details from component specifications. | Use only approved lubricants, coatings, and thread-locking products. Check that any product used is compatible with the motor and operating conditions. |
| Installation condition | Inspect the shaft, thread, mating part, and contact surfaces before assembly. | Parts should be clean and free from burrs, cracks, corrosion, and visible thread damage. | Assemble without cross-threading. Keep debris and liquid away from motor openings, and follow the specified tightening sequence if one is provided. |
| Maintenance and inspection | Set inspection frequency according to duty cycle, environment, and equipment instructions. | There is no single inspection interval suitable for every motor or application; use the manufacturer’s maintenance schedule and applicable site requirements. | With the equipment safely isolated, check for loosening, wear, corrosion, cracks, abnormal vibration, and changes in alignment. Record findings and corrective work. |
| Electrical and mechanical safety | Identify electrical supplies, stored energy, rotating parts, and any hazards from the driven machine. | Isolation and verification procedures must follow the equipment documentation and applicable workplace rules. | Before installation or maintenance, isolate and lock out power, verify the equipment is de-energized, and allow capacitors to discharge as directed by the manufacturer. Refit guards before operation. |
| Final commissioning check | Confirm that the assembly is secure, clear of obstructions, and ready for a controlled test. | Acceptance criteria should match the motor and driven-equipment specifications; stop if there is unexpected noise, vibration, heat, or movement. | Keep personnel clear of rotating parts, start under controlled conditions, and recheck the assembly after shutdown according to the maintenance procedure. |