| Silicone | Excellent flexibility; good adhesion to many nonporous surfaces; retains flexibility over a broad temperature range. | Often high; some products are rated for approximately ±25% to ±50% joint movement. | Excellent resistance to rain, moisture, UV exposure, and outdoor weathering. | Generally not paintable; paint adhesion is poor. | Glass, glazed tile, aluminum, and other compatible nonporous surfaces. Some grades are formulated for specific plastics or stone. | Glazing, sanitary joints, exterior joints, and weatherproofing. | May not adhere well to porous or oily surfaces without the right grade or primer. Some formulations can stain sensitive stone or corrode certain metals; check product guidance. |
| Polyurethane | Good adhesion and abrasion resistance; often forms a durable, elastomeric joint. | Moderate to high; movement ratings vary by grade, with some products rated around ±12.5% to ±25%. | Generally good once cured; outdoor UV exposure may cause surface discoloration or chalking in some formulations. | Often paintable after curing, subject to the product instructions and paint compatibility. | Concrete, masonry, wood, and some metals when the surface is prepared as specified. | Construction joints, concrete control joints, panel joints, and general building repairs. | Surface preparation is important. Some products are sensitive to moisture during application, and uncured material may be affected by water. |
| Silane-Modified Polymer (SMP/MS Polymer) | Combines flexible sealing with useful adhesion; many grades are low-odor and formulated without isocyanates. | Moderate to high; the rated movement capability depends on the specific formulation. | Typically good resistance to moisture and outdoor exposure; performance varies by product. | Many grades are paintable, but a compatibility test is recommended. | Commonly used on concrete, wood, metals, glass, and some plastics, subject to product-specific compatibility. | Building joints, façade and roof details, general bonding, and sealing where a paintable flexible joint is needed. | Not every grade bonds to every plastic or coated surface. Cure rate and paint compatibility vary; follow the technical data sheet. |
| Acrylic (Water-Based) | Easy to tool and clean up before curing; useful for interior joints with limited movement. | Low to moderate; often suited to joints with limited movement rather than highly dynamic joints. | Suitable for many interior applications. Standard grades may have limited resistance to prolonged water exposure; water-resistant grades are available. | Usually paintable after the sealant has dried or cured as directed. | Porous materials such as plaster, drywall, wood, and masonry. | Interior trim, skirting boards, and small gaps around doors and windows. | Can shrink during drying and may crack if the joint moves too much. Not the best choice for continuously wet areas unless specifically rated for them. |
| Butyl | Remains tacky or plastic-like in many formulations; offers good water and air sealing in lap joints. | Low; generally intended for joints with little movement rather than elastic expansion joints. | Good resistance to water and weather when protected or used in a suitable joint design. | Usually not paintable; check the product instructions. | Commonly used on metal, glass, and compatible roofing or building materials. | Roofing laps, flashing, glazing bedding, and concealed joints. | May remain soft and collect dirt when exposed. It is not generally intended for high-movement joints or applications requiring a hard, paintable finish. |
| Epoxy Adhesive | High bond strength and rigidity; suitable for structural bonding when the correct system and design are used. | Very low; cured epoxy is generally rigid and is not intended to accommodate significant joint movement. | Can provide good chemical and moisture resistance, depending on the formulation and exposure conditions. | Some cured epoxies can be coated, but compatibility and surface preparation should be verified. | Many metals, concrete, ceramics, and selected rigid plastics, depending on the epoxy system. | Rigid bonding, repairs, and gap filling where movement is minimal. | Typically less flexible than elastomeric sealants. Mixing, working time, cure conditions, and surface preparation are critical. |