| 1. Set a site-specific power factor target | Displacement power factor, active power (kW), and reactive power (kvar) | Review utility tariff terms and equipment requirements. A target near 0.95 lagging is commonly used as a planning reference, but the applicable target depends on the site and utility. Avoid sustained leading power factor. | At commissioning; review after major load or tariff changes |
| 2. Track performance across changing loads | Power factor and kvar by time of day, operating shift, and major load state | Use interval data or a power-quality meter to compare low-load and peak-load periods. Repeated low readings may indicate insufficient correction; leading readings at light load can indicate excessive fixed compensation. | Review trends monthly and after process changes |
| 3. Check capacitor-step operation | Controller target, step status, switching frequency, and kvar response | Confirm that steps switch in response to changing reactive demand and that the displayed step status matches the installed equipment. Frequent hunting or steps that never operate may point to incorrect settings, sensing, or a failed component. | Check alarms monthly; verify during scheduled maintenance |
| 4. Watch for harmonics and resonance risk | Voltage and current harmonic distortion, capacitor current, and signs of overheating | Assess harmonic conditions where nonlinear loads such as variable-speed drives or rectifiers are present. Compare measurements with applicable site and utility limits; have a qualified engineer evaluate detuned or filtered solutions when needed. | At system design and commissioning; repeat after significant load additions or unexplained alarms |
| 5. Inspect capacitors and switching components | Bulging or leaking cases, discoloration, loose connections, contactor condition, and abnormal noise or odor | Look for physical deterioration and signs of heat. Any electrical inspection or work inside the panel should follow site isolation procedures and be performed by qualified personnel. | Visual inspection at the site’s planned maintenance interval; investigate promptly if symptoms appear |
| 6. Verify operating temperatures and ventilation | Panel temperature, ambient conditions, fan operation, and unobstructed airflow | Compare measured temperatures with the component and enclosure ratings. Clean blocked ventilation paths and investigate recurring hot spots rather than relying on a single temperature reading. | During routine inspections and whenever temperature alarms occur |
| 7. Keep records and review lifecycle costs | Power factor trends, kvar supplied, alarms, maintenance actions, and utility charges | Maintain dated readings and service records. Compare utility bills before and after changes, accounting for operating hours and production levels; use the results to plan repairs, replacement, or capacity adjustments. | Review monthly or each billing cycle |