| 1. Match the conversion speed to your signal | Successive-Approximation Register (SAR) ADC | Uses a comparator and internal DAC to test digital codes one bit at a time, from the most significant bit to the least significant bit. | Offers a practical balance of speed, resolution, power consumption, and predictable conversion time. | Very high sample rates or very high resolution may require a different architecture; input settling and sampling behavior need consideration. | Data acquisition, control systems, portable instruments, and multiplexed sensor inputs. |
| 2. Prioritize low noise and high resolution for slower signals | Sigma-Delta ADC | Oversamples the input, shapes quantization noise away from the signal band, then uses digital filtering and decimation to produce output samples. | Can provide high resolution and strong in-band noise performance at low to moderate signal bandwidths. | Digital filtering introduces latency; the output data rate and usable signal bandwidth are lower than the internal sampling rate. | Precision measurement, scales, temperature sensing, audio, and low-frequency instrumentation. |
| 3. Choose a pipeline architecture for sustained high throughput | Pipeline ADC | Divides conversion into stages; each stage resolves part of the code and passes a residue to the next stage. | Supports high sampling rates while providing more resolution than is generally practical with a full flash architecture. | Pipeline stages add latency, and performance can depend on clock quality, calibration, and input frequency. | Communications receivers, imaging systems, and high-speed data acquisition. |
| 4. Use flash conversion when minimum latency matters most | Flash ADC | Compares the input simultaneously against a bank of reference thresholds using many comparators, then encodes the results. | Very fast conversion with extremely low conversion latency. | Comparator count grows rapidly with resolution, increasing circuit area and power; practical resolution is usually lower than in slower architectures. | Very high-speed signal capture, radar systems, and fast transient measurement. |
| 5. Favor integrating conversion for stable, low-frequency measurements | Dual-Slope Integrating ADC | Integrates the unknown input for a fixed interval, then applies a reference of opposite polarity and measures the time needed for the integrator output to return to zero. | Provides good accuracy and can reject periodic interference when the integration interval is chosen appropriately. | Conversion is relatively slow, so it is not suitable for rapidly changing signals. | Digital meters and precision measurement of slowly varying voltages. |
| 6. Consider a simple ramp converter when speed requirements are modest | Single-Slope (Counter-Ramp) ADC | A counter drives a DAC to create a stepped ramp; a comparator stops the count when the ramp reaches the input voltage. | Uses a straightforward conversion process and can be suitable where circuit simplicity is important. | Conversion time varies with input level and can be long; accuracy depends on the clock, DAC, and comparator behavior. | Simple, low-speed measurement circuits and educational demonstrations. |
| 7. For remote or noisy measurements, consider encoding voltage as frequency | Voltage-to-Frequency Converter | Produces an output pulse train whose frequency is proportional to the input voltage; a counter or timer measures the pulses to obtain a digital value. | Pulse signals can be convenient to transmit over longer distances and can be counted using simple digital hardware. | Requires a measurement interval to estimate frequency; conversion speed, resolution, and accuracy depend on the converter and counting method. | Remote sensors, isolated measurement links, and systems that already include pulse-counting inputs. |