| 1 | Battery safety documentation | Test report or certification documentation identifying the exact cell or battery model used in the power bank. | Check applicability of IEC 62133-2, which specifies safety requirements and tests for portable sealed secondary lithium cells and batteries under intended use and reasonably foreseeable misuse. | Match the documented model to the battery installed in every device configuration being offered. |
| 2 | Transport-test documentation | UN 38.3 test summary for the relevant lithium battery type, with model identification and test-laboratory details. | Lithium batteries offered for transport are subject to applicable UN Manual of Tests and Criteria, subsection 38.3 requirements. IEC 62133-2 does not replace UN 38.3 transport testing. | Request updated documents when battery design, cell type, or manufacturing source changes. |
| 3 | Rated energy and capacity labeling | Product label and technical sheet showing rated voltage, capacity in ampere-hours or milliampere-hours, and watt-hours. | Watt-hours can be calculated as: Wh = nominal voltage (V) × capacity (Ah). For example, 3.7 V × 20 Ah = 74 Wh. | Use the rated Wh value—not only the mAh figure—for aviation screening and inventory records. |
| 4 | Air-travel threshold awareness | Written handling guidance for staff and customers carrying power banks on passenger aircraft. | Power banks are treated as spare lithium batteries: they must be carried in cabin baggage, not checked baggage. Up to 100 Wh is generally permitted without airline approval; above 100 Wh and up to 160 Wh generally requires airline approval and is limited to two spare batteries per passenger. More than 160 Wh is not permitted in passenger baggage. Airline rules can vary. | Provide clear customer instructions and direct travelers to confirm rules with their airline before departure. |
| 5 | Battery protection and electrical design | Technical description of the battery-management and protection circuitry, including overcharge, over-discharge, overcurrent, and short-circuit protections where applicable. | Protection features should be documented for the offered design; their presence does not by itself establish compliance with a safety standard. | Confirm protection behavior for the supplied battery, charging input, and output ports. |
| 6 | Cell and batch traceability | Records linking battery model, production batch, manufacturing date, and finished power-bank units. | Traceable identification supports incident investigation, targeted quarantine, and recall actions; it is not a substitute for safety testing. | Check that returned units can be linked to a batch or serial-number record. |
| 7 | Charging system compatibility | Input ratings, supported charging protocols, charger specifications, and instructions for approved charging accessories. | Charging equipment must be used within the power bank’s stated input ratings. Do not assume that a connector type alone confirms compatibility. | Assess whether the charging setup supports the expected fleet volume without exceeding the documented ratings. |
| 8 | Inspection and damaged-unit process | Inspection checklist and written procedures for swollen, leaking, unusually hot, damaged, or recalled units. | Damaged or defective lithium batteries can present fire risks and should not be treated as ordinary reusable stock or transported without appropriate guidance. | Verify that staff can isolate suspect units and escalate them through a documented process. |
| 9 | Charging-station and fleet support | Station specifications, installation instructions, maintenance guidance, and service-response terms. | Check station electrical ratings and the supplier’s documented operating conditions; no single station capacity or service level is a universal safety standard. | Compare compatibility with the planned site layout, usage pattern, and maintenance resources. |
| 10 | Ongoing compliance and change control | Revision-controlled product specifications, change notices, warranty terms, and a process for reporting safety issues. | Confirm that documentation remains applicable after changes to cells, battery packs, electronics, or manufacturing sites. | Make advance notification of safety-relevant product changes part of the purchasing agreement. |