| Excessive water temperature | Water discharges while the geyser is heating; hot water may be unusually hot. | The valve opens when temperature or pressure exceeds its rated limit. A thermostat fault can allow water to overheat. | Stop using the heater if overheating is suspected and have the thermostat and heating controls checked by a qualified technician. | Prompt attention |
| Excessive water pressure | Dripping continues even when the geyser is not actively heating, or other plumbing fixtures show unusually high pressure. | Pressure above the valve’s rating can make it release water to protect the cylinder. | Ask a plumber to measure the supply pressure and check any pressure-reducing equipment. Do not adjust the valve yourself. | Arrange a check |
| Thermal expansion in a closed system | A small amount of water appears during a heating cycle, then stops after the water cools. | Water expands as it heats. In a system that prevents expansion from returning to the supply, pressure can rise and trigger the relief valve. | Have a qualified plumber check whether the system’s expansion-control components are suitable and functioning correctly. | Monitor and arrange a check |
| Worn, corroded, or contaminated valve | The valve drips continuously, leaks after a discharge event, or shows visible corrosion or mineral deposits. | Wear, corrosion, or debris on the sealing surface can prevent the valve from closing fully. | Have the valve inspected and replaced if necessary with a correctly rated, compatible safety valve. Never seal the leak with tape or a plug. | Arrange repair |
| Leak at a pipe connection or fitting | Water appears around the valve threads or pipe joint rather than from the valve’s discharge outlet. | A loose, damaged, or poorly sealed connection may leak independently of the valve’s safety operation. | Ask a plumber to identify the leak source and repair the connection. Do not tighten or dismantle a hot, pressurized valve. | Arrange a repair |